Chewing Gum Remover is an innovative ready-to-use liquid which actually lifts and prepares a gum wad for removal by a machine from carpeting, upholstery and fabric with our Stainless Steel Brush. Chewing Gum Remover removes gum wads without sticky residue, non-resoiling and detergent free. It disallows deeper penetration of gum into most surfaces through its lifting action. Furthermore, this high performance remover can be used for the removal of a multitude of non-water-soluble spots and stains.
Application/Substrates:
Chewing Gum Remover can be applied on all solvent-resistant and colourfast surfaces, i.e. carpeting, upholstery, clothing, drapes, hard and stone floors, etc.
Always pre-test carpet, fabric or surface to be treated (use of brush, machine) in an inconspicuous area before proceeding. Will not harm carpet backing.
Technical Data:
Odour: citrus Colour: Clear: no pH-value: n.a. neutral
Storage: frostfree in closed containers. Keep away from strong oxidation and reduction agents
Dilution ratio:
Chewing Gum Remover is a ready-to-use solution and must not be diluted.
Method of Application:
Carpeting:
Wet entire surface and fringe of gum wad with Chewing Gum Remover. Allow a few seconds for lifting action. Use a machine to abrade gum wad with Stainless Steel Brush. Brush should be moved with brisk strokes across grain of carpet, then repeat movement with the grain of the carpet. Gum wad should be removed without sticky residue. Old and deeply imbedded gum may require an extra application with repeated agitation. Chewing gum removal together with textile cleaning: in order to avoid re-soiling, we recommend treatment with our detergent-free carpet cleaning products, i.e.
On Upholstery and other Fabrics:
Do not use Stainless Steel Brush on this surface. Aggressive brush agitation may permanently damage these sensitive surfaces.
Replace brush with a standard green scrubbing pad, mechanical abrasion is still required to achieve best results. Unsightly dirt stuck to the top of the gum wad may spread into the surrounding area once Chewing Gum Remover is applied. Avoid creating a ?dirt stain? by removing dirt prior to cleaning by blotting with a rag dampened with Chewing Gum Remover.
Brush Maintenance: Allow brush to soak in Chewing Gum Remover for 5 minutes. Remove any excess gum with a clean absorbent cloth before continuing use.
Disposal/Storage/Transport/Precautions:
Chewing Gum Remover is a subject to special marking cleaner. Upon request we will provide you with service instruction according to Hazardous Substances Ordinance. May be put into the sewerage system only if abundantly diluted with water. In case of direct contact with the product, wear solvent-resistant gloves. Immediately remove all contaminated clothing. If swallowed, do not induce vomiting. Seek medical advice immediately and show the container or label. The relative Health and Safety Information, safety and risk phrases are indicated on the package and in our EC Safety Data Sheet. Keep out of reach of children.
All recommendations are based on practical experience, but should be modified, if necessary, to conform with different practice conditions. We cannot claim to serve in any but an advisory capacity and can undertake no liability. Tests should be carried out in each individual case before the work is started.
(SOL65)
The post Chewing Gum Remover 500ml appeared first on Cleaning Warehouse - Cleaning Products Suppliers Dublin.
